Dillon GS Plus Force Gauge Manual de usuario

GS Series User’s Manual

GS series User’s Manual REV 2.1 22/01/12 10 Main Menu Press MENU/ESC key to access the main menu. To move between the option listed on the main m

GS series User’s Manual REV 2.1 22/01/12 11 2) PASS-FAIL the Pass-Fail feature used to set a defined acceptable maximum and minimum forces gap for

GS series User’s Manual REV 2.1 22/01/12 12 example LOWER LEVEL = 20 N, UPPER LEVEL = 0 N Load The “OK” LED will ON. Another LED

GS series User’s Manual REV 2.1 22/01/12 13 Figure 7a Memory Page Press UP and DOWN to change memory page, press and hold to scroll cha

GS series User’s Manual REV 2.1 22/01/12 14 A total of overload count % offset of last calibrate % curr

GS series User’s Manual REV 2.1 22/01/12 15 Measurement practice For best measurement accuracy keep the compression/tension forces in line with t

GS series User’s Manual REV 2.1 22/01/12 16 GS Specifications Capacity and Divisions Capacity (N) mN N kN g-f kg-f oz-f lb-f 5 5000 x 2 5 x 0.0

GS series User’s Manual REV 2.1 22/01/12 17 Conversion Factor Unit mN N kN g-f kg-f oz-f lb-f mN 1 0.001 1e-6 101.97e-3 101.97e-6 3.597e-3

GS series User’s Manual REV 2.1 22/01/12 18 Dillon, a Weigh-Tronix Brand 1000 Armstrong drive Fairmont, Minnesota 56031 Sales (50

GS series User’s Manual REV 2.1 22/01/12 2 Table of Contents Table of Contents…………………………………………………………… 2 Introduction…………………………………………………………………… 3

GS series User’s Manual REV 2.1 22/01/12 3 Introduction Thank you for choosing the Dillon GS series instrument. With correct use and regular re-c

GS series User’s Manual REV 2.1 22/01/12 4 Powering the first time The GS is supplied with a set of 4 Nickel Metal Hydride AA rechargeable batte

GS series User’s Manual REV 2.1 22/01/12 5 Using the GS Fitting Accessories Couple fittings directly to the load cell stem or use an extension rod

GS series User’s Manual REV 2.1 22/01/12 6 To power up the gauge press the ON/OFF key. A short self-test runs during which the display will show the

GS series User’s Manual REV 2.1 22/01/12 7 A load indicator bar alerts the operator to how much load has been applied to the load sensor. For tensi

GS series User’s Manual REV 2.1 22/01/12 8 Peak-Tension mode Press MODE key until the appeared on the display. The display will show the maxi

GS series User’s Manual REV 2.1 22/01/12 9 Saved reading to memory Any reading can be saved anytime by press MEM/ENTER key. A total of 500 readin