Dillon U Force Gauge Manual de usuario descargar pdf (Pagina 1)

The Dillon Universal Force Gauge bears a serial number stamped on a

permanent nameplate. Please refer to this number and mention capacity of

the instrument should it ever be necessary to contact your supplier.

To adjust for precise zero, loosen the knurled screw on the side of the

indicator bezel slightly and rotate the bezel in either direction as required.

Then retighten the knurled screw. It may be necessary to repeat this opera-

tion several times to secure exact zero setting.

If the gauge is to be used for setting electrode pressure in resistance welders,

be sure to disconnect power before making measurements. A warning

sticker to this effect is on the end of the Force Gauge.

All units with a flat bottom surface may be placed on any flat surface with the

load applied to a single pressure fitting on the top of the deflection beam. It is

important to apply force only at the center of the loading points as shown in

Figure 2. Standard instruments with a recess on the bottom surface will

produce readings on a flat surface but such readings will not be accurate.

Larger capacity gauges have a mounting hole in the bottom to accept cus-

tomer jigs.

Dillon Universal Force Gauges are carefully machined and are calibrated with

certified laboratory testing equipment or weights. With reasonable care, they

will provide many years of satisfactory service.

Load must be applied to the Dillon Universal Force Gauge ONLY at point "A"

shown in Figure 1. Inaccurate readings will result at "B" or "C". Be sure force

is applied in a straight line as shown by the arrows.

Figure 1

Recessed bottom gauges

Dillon Universal Force Gauge

Correct Methods of

Applying Load

Operation

1 2

The Dillon Universal Force Gauge bears a serial number stamped on apermanent nameplate. Please refer to this number and mention capacity ofthe instru

Weigh Bar® is a registered trademark of Weigh-Tronix Inc02/24/03 UNIVERSL.P65 PN 16944-0013E e1 Printed in USADillonA division of Weigh-Tronix Inc.

Sin comentarios

Dillon U Force Gauge Manual de usuario Pagina 1